JSHD 3 Position Enabling Device Accessories

Accessories

8 Pole Mini Series Size II

Available in standard cable lengths of 6, 12, 20, 30 or 40* feet with 18AWG wire. Custom lengths are available upon request and are subject to a minimum quantity requirement. (*only in PVC)

4 Pole Micro DC (M12)

Standard cable lengths of 2, 5, or 10meters with 18AWG wire in PVC or 22AWG wire in PUR cable. Custom lengths are available upon request and are subject to a minimum quantity requirement.

Panel Mount Receptacles

Both 8 Pole Mini Series Size II and 4 Pole Micro DC (M12) style female versions available with 1/2" NPT mounting and 18AWG wire.

Standard wire lengths of 12, 36 or 72 inches for the 8 pole style and 0.3 or 1 meter for the 4 pole style. Custom lengths are available upon request and are subject to a minimum quantity requirement.

Terminating Plugs

Both 8 Pole Mini Series Size II and 4 Pole Micro DC (M12) style male versions available with pins 1-2 and 3-4 shorted.

Pendant Holster

The pendant holster can be used for a variety of applications, including:

• Disabling of robot hazardous motion
• Disabling of external reset buttons to prevent unintentional start-ups
• Disabling of input devices to allow access to the hazardous area of other equipment within a cell, such as transfer stations, while using the enabling device.

The non-safety NO contact on the pendant holster safety interlock switches can be used to provide a software or visual signal to indicate that the enabling device has been removed from the pendant holster.

Interlock Switch Pendant Holster

The Enabling Device Pendant Holster consists of two safety interlock switches mounted to a U-channel wall mounting bracket. Each safety interlock switch contains two NC positive opening and one NO contact.

The actuator from each safety interlock switch is mounted to the standard large bottom plate of the enabling device. The enabling device is then inserted into the pendant holster. The safety interlock switches provide a very strong and secure holder for the enabling device while providing the customer user interface contact to perform various functions.

Eden Pendant Holster

The Eden Enabling Device Pendant Holster consists of a two-piece metal bracket and is designed for use with the Adam and Eva non-contact, non-magnetic safety switch and the JSHD4 Enabling Device.

The top bracket (JSM53A) is formed to step-up near the center of the bracket. The lower end of this bracket is pre-drilled with four holes to attach the enabler pendant handle with screws and a M16 threaded opening for enabling device cable or bulkhead connector. The stepped-up end of the top bracket is drilled and tapped with two 4 mm holes to attach the Eva or Eva E side of the Eden Safety Switch. A beveled guide pin is welded to the underside of the stepped-up end of the top bracket and will fit into a pre-drilled hole with metal tube welded to the underside of the lower bracket.

The lower bracket (JSM54) is formed with a 90º angle that has pre-drilled holes for attachment to walls, panels or fencing. The rest of the bracket has two drilled and tapped 4 mm holes to attach the Adam or Adam E side of the Eden Safety Switch and is shaped to mate with the top bracket. This allows for the insertion of the guide pin into the pre-drilled hole and properly positions the Adam and Eva Safety Switch. The Eden Pendant Holster comes assembled with Enabling Device or can be ordered without the Enabling Device to retrofit your current enabling device.