Quick-Guard® - Assembly Using net-Locks NL2 and NL3 on welded Mesh

NL2 Net-Lock

When assembling the Net-Lock NL2 it is first put into the profile as the drawing shows. Then the Net-Lock is turned 90°. When cutting the welded mesh the wire ends should not be longer than 2mm.

NL3 Net-Lock

When assembling the Net-Lock NL3 it is first put into the profile with the clotches on each side of the mesh wire. The screw is then tightened. When cutting the welded mesh the wire ends should not be longer than 2 mm.

Number of Net-Locks
Standard Version

On Quick-Guard Standard Version Net-Lock NL3 is recommended as it can handle mesh with and without an outer wire.

Number of Net-Locks
Quick-Guard E

On Quick-Guard E both Net-Lock NL2 and NL3 can be used. For mesh edges without outer wire NL3 must be used instead of NL2.

Note: On both Quick-Guard and Quick-Guard E at least two NL3 should be used in order to mechanically lock the mesh and to electrically ground the mesh. On doors only NL3 should be used.